FLY FLYF407ZG Klipper Firmware
Required Items
- Klipper must be installed onto the Raspberry Pi
- At least one microSD card needs to be available depending on number of controllers.
Build Firmware Image
- Login to the Raspberry Pi
- Run the following:
sudo apt install make
cd ~/klipper
make menuconfig
In the menu structure there are a number of items to be selected.
- Ensure that “Enable extra low-level configuration options” is selected
- Ensure that the micro-controller architecture is set to ‘STMicroelectronics STM32’
- Ensure that the Processor model is set to “STM32F407”
- Ensure that the Bootloader offet is set to “32KiB bootloader”
- Ensure that Clock Reference is set to “8 MHz crystal”
- Ensure that “Use USB for communication (instead of serial)” is selected
Once the configuration is selected, select “Exit” and “Yes” if asked to save the configuration.
Run the following:
make clean
make
The make command, when completed, creates a firmware file klipper.bin that is store in the folder /home/pi/klipper/out. This file need to be copied to the FLY board. The easiest way to do this is to use a GUI like WinSCP on Windows or either Cyberduck or scp (from terminal) on Mac to copy the file to your computer.
Load Firmware Image
Copy the klipper.bin to the desktop, then rename it to firmware.bin
Important: If the file is not renamed, the bootloader will not be updated properly.
Ensure that the FLY board is not powered, then remove the microSD card that is installed.
Connect the microSD card to the computer with the firmware.bin file. Open the microSD card in the file browser. There may be a file named ‘fly.cur’; that file can be deleted or left alone, it will be overwritten later.
Copy the firmware.bin from the desktop onto the microSD card. If problems are encountered transferring the file(s) to the microSD card, reformat the microSD card with a FAT32 filesystem and try again.
Replace the microSD card(s) into the FLY. If more than one, it does not matter which card goes into which controller.
Turn on the power supply to power on the FLY board. If named properly, the FLY will automatically update with the Klipper firmware.
Important: If the FLY not powered with 12-24V, Klipper will be unable to communicate with the TMC drivers via UART and the FLY will automatically shut down.