Voron V1 - SKR 1.4 Wiring

Initial Preparation

If using the TMC2209 stepper drivers, use a small pair of wire cutters and remove the pin marked in purple. This is to disable sensorless homing which is not needed for the V2.

Place stepper drivers for X, Y, Z, Z1, and E in positions X, Y, Z, E0, and E1
Plug in stepper motors for X, Y, Z, Z1, and E in positions X, Y, Z, E0, and E1 (one of the Z connectors will be empty)
Plug Hot End thermistor to thermistor TH0 (P0.24)
Plug Hot End heater in to HE0 (P2.7)
Plug Hot End Fan + Controller Fan in to HE1 (P2.4)
Plug Bed Heater thermistor in to TB (P0.23)
Plug SSR Control for Heated Bed in to Neopixel (P1.24)
Plug Part Cooling Fan in to Fan (P2.3)
Connect X end stop to X-STOP connector (P1.28)
Connect Y end stop to Y-STOP connector (P1.26)
Connect Z end stop to Z-STOP connector (P1.25)
Plug Probe PWR and GND into FAN2
Plug Probe Signal (with BAT85 diode) in to Probe (P0.10)
Plug in Exhaust Fan in to HB (P2.5)
Plug display wires in to EXP1 and EXP2
Wire 24V and 0V from DC power supply to Power In
Connect USB Cable to your SKR 1.4, but do not connect it yet to your Raspberry Pi

For reference, here is the pinout of the SKR 1.4