Voron V0.0 - SKR mini E3 V1.2 Wiring

MCU

Plug in stepper motors for X, Y, Z, and E in positions Xm, Ym, Zm, and Em
Plug Hot End thermistor to thermistor TH0
Plug Hot End heater in to E0
Plug Hot End Fan in to FAN0
Plug Part Cooling Fan in to HB
Plug Bed Thermistor in to THB
Connect SSR pins to PT-DET connector
- Crydom SSR: SSR Input + => PC12, SSR Input => GND
- MagicStudios / Knacro 1-Channel SSR: CH1 => PC12, DC- => GND, DC+ => NC
Connect X end stop to X-STOP connector
Connect Y end stop to Y-STOP connector
Connect Z end stop to Z-STOP connector
Wire 24V and -V from DC power supply to VIN and GND
Connect USB Cable to your SKR mini E3, but do not connect it yet to your Raspberry Pi

The MagicStudios / Knacro SSR requires 3 wires instead of the 2 referenced above.

Knacro Wiring

For reference, here is the pinout of the SKR mini E3 V1.2