Trident Gantry Wires
This chart only includes what goes into the cable chains to the gantry. It does NOT include exhaust fan, filament runout sensor, or other non-essential wiring.
Lengths
| Chain | 250x250x250 | 300x300x250 | 350x350x250 |
|---|---|---|---|
| X (Toolhead) | 190cm | 200cm | 210cm |
| Y (Endstop Pod) | 160cm | 165cm | 170cm |
| Z (Bed) | 100cm | 100cm | 100cm |
Wire Counts
| Chain | Signal | 24AWG | 20 AWG |
|---|---|---|---|
| X | Hot End Heater | 2 | |
| X | Thermistor | 2 | |
| X | Extruder Motor | 4 | |
| X | Inductive Probe | 3 | |
| X | Hot End Fan | 2 | |
| X | Part Fan | 2 | |
| Y | X Endstop | 2 | |
| Y | Y Endstop | 2 | |
| Z | Ground | 1 | |
| Z | Bed Heater | 2 | |
| Z | Bed Thermistor | 2 | |
| Z | Z Endstop | 2 |